"4/3" redirects here. For 4:3 image aspect ratio, see Aspect ratio (image)#4:3 standard.

The Four Thirds system is a standard created by Olympus and Kodak for digital single-lens reflex camera (DSLR) and mirrorless camera design and development.[1]

The system provides a

Unlike older SLR systems, Four Thirds has been designed from the ground up to be entirely digital. Many lenses are extensively computerized, to the point that Olympus offers firmware updates for many of them. Lens design has been tailored to the requirements of digital sensors, most notably through telecentric designs. The size of the sensor is significantly smaller than for most DSLRs and this implies that lenses, especially telephoto lenses, can be smaller. For example, a Four Thirds lens with a 300 mm focal length would cover about the same angle of view as a 600 mm focal length lens for the 35 mm film standard, and is correspondingly more compact. Thus, the Four Thirds System has crop factor (focal length multiplier) of about 2, and while this enables longer focal length for greater magnification, it doesn't aid the manufacture of wide angle lenses.

The image sensor format, generally intermediate between those of larger SLRs and smaller compact cameras, generally gives levels of cost, performance and convenience intermediate between those two classes.

Sensor size and aspect ratio

The name of the system stems from the size of the image sensor used in the cameras, which is commonly referred to as a 4/3" type or 4/3 type sensor. The common inch-based sizing system is derived from vacuum image-sensing video camera tubes, which are now obsolete. The imaging area of a Four Thirds sensor is equal to that of a video camera tube of 4/3" diameter.[3]

The usual size of the sensor is 18 mm × 13.5 mm (22.5 mm diagonal), with an imaging area of 17.3 mm × 13.0 mm (21.63 mm diagonal).[3][4] The sensor's area is about 30–40% smaller than APS-C sensors used in most other DSLRs, but still around 9 times larger than the 1/2.5" sensors typically used in compact digital cameras. Incidentally, the imaging area of a Four Thirds sensor is almost identical to that of 110 film.

The emphasis on the 4:3 image aspect ratio sets Four Thirds apart from other DSLR systems, which usually adhere to the 3:2 aspect ratio of the traditional 35 mm format. However, the standard only specifies the sensor diagonal, thus Four Thirds cameras using the standard 3:2 aspect ratio would be possible;[5] notably newer Panasonic Micro Four Thirds models even offer shooting at multiple aspect ratios while maintaining the same image diagonal. For instance, the Panasonic GH1 uses a multi-aspect sensor designed to maximize use of the image circle at 4:3, 3:2, and 16:9; each ratio having a diagonal of 22.5 mm.[6]

Sensor aspect ratio has an impact on lens design. For example, many lenses designed by Olympus for the Four Thirds system contain internal rectangular baffles or permanently mounted "petal" lens hoods that optimise their operation for the 4:3 aspect ratio.

In an interview John Knaur, a Senior Product Manager at Olympus, stated that "The FourThirds refers to both the size of the imager and the aspect ratio of the sensor".[7] He also pointed out the similarities between 4:3 and the standard printing size of 8×10 as well as medium format 6×4.5 and 6×7 cameras, thus helping explain Olympus' rationale on choosing 4:3 rather than 3:2.

Advantages, disadvantages and other considerations


  • The smaller sensor size makes possible smaller and lighter camera bodies and lenses. In particular, the Four-Thirds system allows the development of compact, large aperture lenses. Corresponding lenses become larger, heavier and more expensive when designed for larger sensor formats.
  • Telecentric optical path means that light hitting the sensor is traveling closer to perpendicular to the sensor, resulting in brighter corners, and improved off-center resolution, particularly on wide angle lenses.
  • Because the flange focal distance is significantly shorter than those on Canon FD, Canon EF, Nikon F and Pentax K, lenses for many other SLR types including the old Olympus OM System can be fitted to Four Thirds cameras with simple mechanical adapter rings. Such mechanical adapter rings typically require manual setting of focus and aperture. A series of tests [9] provides a demonstration.
  • A smaller sensor produces a deeper depth-of-field, for the same lens aperture, reducing the risk of out-of-focus photos.


  • The main disadvantage of a smaller sensor, with a pixel count that matches a larger sensor, is the reduction in incoming light hitting the light sensitive part of each pixel of the sensor. This is true even if the Four Thirds camera and lens is properly designed to focus all captured light onto the smaller light circle circumscribing the smaller sensor. The reason is that a smaller pixel has a proportionately smaller light sensitive area because the pixel loses a larger proportion of its total area to secondary circuitry and edge shading than a larger pixel. With less captured light to work with each pixel output voltage requires additional amplification with associated higher signal noise, resulting in increased chromatic and color noise as well as reduced dynamic range. A telecentric lens design helps reducing this problem but still leaves a smaller sensor, with smaller pixels, more sensitive to the angle of incoming light, among other things producing a more pronounced image corner light fall off.
  • The resolution of a sensor is often measured as the total sensor pixel count in Mega Pixels or MP. From an image resolution point of view a large sensor consisting of small sensor pixels is therefore desirable. The resolution of a lens is typically defined as the ability to produce an image of for example 100 black and white line pairs per millimeter. This corresponds to a line pair distance of 10 µm. Since this is also in the neighborhood of how small we can make the pixels today this puts a limit on what image resolution we can achieve in a Four Thirds image sensor. Smaller pixels consequently also place a greater demand on lens resolution in order to be able to take advantage of the higher image sensor resolution. The noise, ISO and dynamic range performance of a Four Thirds sensor is therefore about 2/3 of that of an APS-C sensor or about 1/4 of that of a full-frame 35 mm sensor. [10]
  • Because of the higher crop factor, an image shot at a given relative aperture and angle of view has more depth of field on Four Thirds.[11] This results in less control over depth of field, compared to larger formats. For instance, a 35 mm full frame DSLR can match the depth of field of a Four Thirds camera by closing down the aperture by two stops; but it may be more difficult or impossible for a Four Thirds system to match the shallow depth of field of a 35 mm full frame camera with fast lenses.


  • Most Four Thirds cameras (notably those manufactured by Olympus) use an aspect ratio of 4:3 rather than 3:2; newer models offer cropping to 3:2, but this results in a reduced image diagonal (i.e., the effective crop factor is then 2.08).

Four Thirds system companies

As of the 2006 Photo Marketing Association Annual Convention and Trade Show, the Four Thirds consortium consisted the following companies:

This does not imply a commitment to end user products by each company. Historically, only Leica, Olympus, and Panasonic have produced bodies. Olympus and Leica/Panasonic make dedicated Four Thirds lenses, and Sigma makes adapted versions of their "DC" lenses for APS-C format DSLRs. Kodak once sold sensors to Olympus for use in their Four Thirds bodies, but the newer Olympus Four Thirds cameras used Panasonic sensors.

Four Thirds system cameras

The majority of Four Thirds system cameras (and Four Thirds lenses) are made by Olympus. Many Four Thirds cameras use "sensor-shift" in-body image stabilization, making the need for image stabilization technology in its lenses unnecessary. All Four Thirds cameras also incorporate an automatic sensor cleaning device, in which a thin glass filter in front of the sensor vibrates at 30 kHz causing dust to fall off and adhere to a piece of sticky material below. Olympus' E-system camera bodies are noted for their inclusion of a wide range of firmware-level features and customization, good JPEG engine, and compact size. Because of the smaller format of Four Thirds, the viewfinders tend to be smaller than on comparable cameras.[12][13] All the cameras listed below are SLR cameras and thus have optical viewfinders.

Manufacturer Camera Name MP Release Date Notes
Olympus E-1 5.1 June 2003 discontinued
Olympus E-300 8.0 September 2004 discontinued
Olympus E-500 8.0 September 2005 discontinued
Olympus E-330 7.5 January 2006 discontinued
Panasonic Lumix DMC-L1 7.5 February 2006 discontinued
Leica Digilux 3 7.5 September 2006 discontinued
Olympus E-400 10.0 September 2006 discontinued
Olympus E-410 10.0 March 2007 discontinued
Olympus E-510 10.0 March 2007 discontinued
Panasonic Lumix DMC-L10 10.1 August 2007 discontinued
Olympus E-3 10.1 November 2007 discontinued
Olympus E-420 10.0 March 2008 discontinued
Olympus E-520 10.0 May 2008 discontinued
Olympus E-30 12.3 November 2008[14]
Olympus E-620 12.3 February 2009[15]
Olympus E-450 10.0 March 2009 discontinued
Olympus E-600 12.3 August 2009 discontinued
Olympus E-5 12.3 September 2010

Four Thirds system lenses

The Four Thirds lens mount is specified to be a bayonet type with a flange focal distance of 38.67 mm.

There are currently around three dozen lenses for the Four Thirds system standard.[16]

Olympus produces about 20 lenses for the Four Thirds system under Zuiko Digital brand. They are divided into three "grades" (Standard, High Grade and Super High Grade). High Grade lenses have faster maximum apertures but are significantly more expensive and larger, and the Super High Grade zooms have constant maximum aperture over the full zoom range; all but the Standard grade are weather-sealed. Lenses within each grade cover the range from wide-angle to super telephoto.[17][18] The Zuiko Digital lenses are well regarded for their consistently good optics.[19] The following is a table of all current Zuiko Digital lenses:[20]

Wide angle Standard Telephoto Super telephoto Special-purpose
Standard 9–18 1:4–5.6 14–42 1:3.5–5.6
14–45 1:3.5–5.6
17.5–45 1:3.5–5.6
25 1:2.8 "pancake"
40–150 1:3.5–4.5
40–150 1:4–5.6
70–300 1:4–5.6 macro 35 1:3.5 macro
18–180 1:3.5-6.3 superzoom
High Grade 11–22 1:2.8–3.5 12–60 1:2.8–4
14–54 1:2.8–3.5
50–200 1:2.8–3.5 50 1:2 macro
8 1:3.5 fisheye
Super High Grade 7–14 1:4 14–35 1:2 35–100 1:2
150 1:2
90–250 1:2.8
300 1:2.8

Olympus also makes 1.4× and 2× teleconverters and an electronically-coupled extension tube.

Sigma has adapted 13 lenses for the Four Thirds system, ranging from 10 mm to 800 mm, including several for which no equivalent exists: the fast primes (30 mm f/1.4 and 50 mm f/1.4) and extreme telephoto (300–800 mm f/5.6).

Leica has designed four lenses for the Four Thirds system: fast and slow normal zooms and a 14–150 mm super-zoom, all with Panasonic's image stabilization system, and an unstabilized f/1.4 25 mm prime. These are manufactured and sold by Panasonic.

An official list of available lenses can be found on Four-Thirds.org web site.[21]

Micro Four Thirds system

In August 2008, Olympus and Panasonic introduced a new format: Micro Four Thirds.

The new system uses the same sensor, but removes the mirror box from the camera design. A live view preview is shown on either the camera's main LCD or via an electronic viewfinder, as in digital compact cameras. Autofocus is accomplished via a contrast-detect process using the main imager, again similar to digital compact cameras. The goal of the new system is to allow for even smaller cameras, competing directly with higher-end point-and-shoot compact digital cameras and lower-end DSLRs. The smaller flange focal distance allows for more compact normal and wideangle lenses. It also facilitates the use, with an adaptor, of lenses based on other mounting systems, including many manual focus lenses from the seventies and eighties.

In particular, Four Thirds lenses can be used on Micro Four Thirds bodies with an adapter, however, "all of the functions of the Micro Four Thirds System may not always be available."[22]

See also


External links

  • Official Four Thirds System site
  • PDF version (1.7 MiB)
  • Andrzej Wrotniak's pages about the Four Thirds System – includes a complete lens list
  • Four Thirds User – independent site and user-community dedicated to the Four Thirds system, including Micro Four Thirds
This article was sourced from Creative Commons Attribution-ShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, E-Government Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a non-profit organization.